Träningsredskap för dystonidrabbade 2005 (Svenska)Självständigt arbete på grundnivå (kandidatexamen)Studentuppsats (Examensarbete)

Abstract [sv]

The purpose of the project is to develop a tool of training for patients with dystonia. The studies were focused towards mainly microchips and angle sensors. A demand list was produced based on the functions of the commission’s demands. The demands were sorted depending on priority regarding basic functionality. The final solution was implemented using the development tool MPLAB IDE v7.01 and the language used was assembler. Everything was implemented from scratch and was fitted to the available environment. The circuit boards were constructed in Cadence CIS and Cadence Layout Plus. The result is a working tool for training with the ability to save the values of the angle sensors angles with an even intervall. These values can be presented through an interface so that a physiotherapist can see the trainings progress. The interface is run in a HyperTerminal environment that utilizes serial communication over a UART.

Ort, förlag, år, upplaga, sidor

2005.

Nyckelord [sv]

Dystonia

Identifikatorer

URN: urn:nbn:se:hh:diva-12917Lokalt ID: U11985OAI: oai:DiVA.org:hh-12917DiVA, id: diva2:368084

Uppsök

teknik

Anmärkning

Denna uppsats kan beställas från arkivet / This paper can be ordered from the archive. Kontakta / Contact: arkivet@hh.seTillgänglig från: 2010-11-09 Skapad: 2010-11-09 Senast uppdaterad: 2025-10-01Bibliografiskt granskad

Open Access i DiVA

Fulltext saknas i DiVA

Av organisationen

Sektionen för Informationsvetenskap, Data– och Elektroteknik (IDE)

Sök vidare utanför DiVA

GoogleGoogle ScholarTotalt: 103 träffar