Träningsredskap för dystonidrabbade 2005 (svensk)Independent thesis Basic level (degree of Bachelor)Oppgave

Abstract [sv]

The purpose of the project is to develop a tool of training for patients with dystonia. The studies were focused towards mainly microchips and angle sensors. A demand list was produced based on the functions of the commission’s demands. The demands were sorted depending on priority regarding basic functionality. The final solution was implemented using the development tool MPLAB IDE v7.01 and the language used was assembler. Everything was implemented from scratch and was fitted to the available environment. The circuit boards were constructed in Cadence CIS and Cadence Layout Plus. The result is a working tool for training with the ability to save the values of the angle sensors angles with an even intervall. These values can be presented through an interface so that a physiotherapist can see the trainings progress. The interface is run in a HyperTerminal environment that utilizes serial communication over a UART.

sted, utgiver, år, opplag, sider

2005.

Emneord [sv]

Dystonia

Identifikatorer

URN: urn:nbn:se:hh:diva-12917Lokal ID: U11985OAI: oai:DiVA.org:hh-12917DiVA, id: diva2:368084

Uppsök

Technology

Merknad

Denna uppsats kan beställas från arkivet / This paper can be ordered from the archive. Kontakta / Contact: arkivet@hh.seTilgjengelig fra: 2010-11-09 Laget: 2010-11-09 Sist oppdatert: 2025-10-01bibliografisk kontrollert

Open Access i DiVA

Fulltekst mangler i DiVA

Av organisasjonen

Søk utenfor DiVA

GoogleGoogle ScholarTotalt: 103 treff