Träningsredskap för dystonidrabbade 2005 (Swedish)Independent thesis Basic level (degree of Bachelor)Student thesis

Abstract [sv]

The purpose of the project is to develop a tool of training for patients with dystonia. The studies were focused towards mainly microchips and angle sensors. A demand list was produced based on the functions of the commission’s demands. The demands were sorted depending on priority regarding basic functionality. The final solution was implemented using the development tool MPLAB IDE v7.01 and the language used was assembler. Everything was implemented from scratch and was fitted to the available environment. The circuit boards were constructed in Cadence CIS and Cadence Layout Plus. The result is a working tool for training with the ability to save the values of the angle sensors angles with an even intervall. These values can be presented through an interface so that a physiotherapist can see the trainings progress. The interface is run in a HyperTerminal environment that utilizes serial communication over a UART.

Place, publisher, year, edition, pages

2005.

Keywords [sv]

Dystonia

Identifiers

URN: urn:nbn:se:hh:diva-12917Local ID: U11985OAI: oai:DiVA.org:hh-12917DiVA, id: diva2:368084

Uppsok

Technology

Note

Denna uppsats kan beställas från arkivet / This paper can be ordered from the archive. Kontakta / Contact: arkivet@hh.seAvailable from: 2010-11-09 Created: 2010-11-09Bibliographically approved

Open Access in DiVA

No full text in DiVA

By organisation

School of Information Science, Computer and Electrical Engineering (IDE)

Search outside of DiVA

GoogleGoogle ScholarTotal: 29 hits