Generic CAN interface 1999 (English)Independent thesis Basic level (degree of Bachelor)Student thesis

Abstract [en]

This Bachelor of Science thesis describes a system that can be used for monitoring and sending CAN messages in a CAN based fieldbus network. The system can send and receive messages at a CAN bus, directly through the CAN protocol and can therefore be used in all fieldbus system based on the CAN protocol. To achieve this functionality the system has been divided into two parts, a generic hardware, with software for CAN based fieldbus systems and a Windows application that acts like an interface to the hardware module. With further extensions of the Windows application the system will be able to work as a fieldbus configurator. The system can then be used to configure all types of CAN networks independent of which CAN standard being used. This thesis describes, the software used in the hardware and the Windows application. The thesis also contains information of the architecture of the system and a short introduction to fieldbus systems and CAN.

Place, publisher, year, edition, pages

1999.

Keywords [en]

CAN, monitor, fieldbus

Identifiers

URN: urn:nbn:se:hh:diva-8296Local ID: U2253OAI: oai:DiVA.org:hh-8296DiVA, id: diva2:363381

Uppsok

Technology

Note

Denna uppsats kan beställas från arkivet / This paper can be ordered from the archive. Kontakta / Contact: arkivet@hh.seAvailable from: 2010-11-09 Created: 2010-11-09Bibliographically approved

Open Access in DiVA

No full text in DiVA

By organisation

School of Business and Engineering (SET)

Search outside of DiVA

GoogleGoogle ScholarTotal: 72 hits