The purpose of this project was to create a gateway between a Z-Wave device and a Bluetooth device.The gateway is supposed to make it possible for the company AES AB to sell and install a dynamic load balancer to their EV charger, even after it’s already been installed. The method that was used during this project was LIPS, where the project where divided into multiple subtargets. Each subtarget then had it’s own test which is shown in the results. The results for the overall project and not just the subtargets, are that a concept solution was created. The concept solution was able to forward the Z-Wave devices values to the Bluetooth device that was the target, but did so using a Raspberry Pi and a Z-Wave stick instead of a Z-Wave transceiver. The conclusion for the bachelor thesis is that the concept solution worked, and the demands of the assignment was fullfilled.