Optisk multigivare 2005 (Svenska)Självständigt arbete på grundnivå (kandidatexamen)Studentuppsats (Examensarbete)

Abstract [sv]

This project aim is to investigate if optical motion sensors placed in computer mice can be used to measure a velocity and decode bar codes. Two different kinds of serial communications have been used. The SIO* interface between the controller and the sensor and the RS232 interface were used between the computer and the controller to present the velocity on a computer monitor. A testing platform was built to preserve a constant environment. The velocity could now be measured to 1 m/s with two decimals accuracy with a program that calculated mean value. Later in the study a median program was developed that was able to measure a velocity up to 1,5 m/s. This is a cheap touchless velocity sensor when the velocity is below 1,5 m/s and a constant distance at 2,4 mm can be kept. The serial communication speed for ADNS-3060 is not adequate for the information needed to decode the bar code with a controller. It is not possible to decode a 40 mm bar code at 1 m/s.

Ort, förlag, år, upplaga, sidor

2005.

Nyckelord [sv]

touchless, velocity, optical sensors, bar codes, mice, optical mice, sensor

Identifikatorer

URN: urn:nbn:se:hh:diva-12912Lokalt ID: U11980OAI: oai:DiVA.org:hh-12912DiVA, id: diva2:368079

Uppsök

teknik

Anmärkning

Denna uppsats kan beställas från arkivet / This paper can be ordered from the archive. Kontakta / Contact: arkivet@hh.seTillgänglig från: 2010-11-09 Skapad: 2010-11-09Bibliografiskt granskad

Open Access i DiVA

Fulltext saknas i DiVA

Av organisationen

Sektionen för Informationsvetenskap, Data– och Elektroteknik (IDE)

Sök vidare utanför DiVA

GoogleGoogle ScholarTotalt: 61 träffar