hh.sePublications
Change search
Link to record
Permanent link

Direct link
BETA
Publications (1 of 1) Show all publications
Kivisaari, P., Berg, A., Karimi, M., Storm, K., Limpert, S., Oksanen, J., . . . Borgström, M. T. (2017). Optimization of Current Injection in AlGaInP Core−Shell Nanowire Light-Emitting Diodes. Nano letters (Print), 17(6), 3599-3606
Open this publication in new window or tab >>Optimization of Current Injection in AlGaInP Core−Shell Nanowire Light-Emitting Diodes
Show others...
2017 (English)In: Nano letters (Print), ISSN 1530-6984, E-ISSN 1530-6992, Vol. 17, no 6, p. 3599-3606Article in journal (Refereed) Published
Abstract [en]

Core–shell nanowires offer great potential to enhance the efficiency of light-emitting diodes (LEDs) and expand the attainable wavelength range of LEDs over the whole visible spectrum. Additionally, nanowire (NW) LEDs can offer both improved light extraction and emission enhancement if the diameter of the wires is not larger than half the emission wavelength (λ/2). However, AlGaInP nanowire LEDs have so far failed to match the high efficiencies of traditional planar technologies, and the parameters limiting the efficiency remain unidentified. In this work, we show by experimental and theoretical studies that the small nanowire dimensions required for efficient light extraction and emission enhancement facilitate significant loss currents, which result in a low efficiency in radial NW LEDs in particular. To this end, we fabricate AlGaInP core–shell nanowire LEDs where the nanowire diameter is roughly equal to λ/2, and we find that both a large loss current and a large contact resistance are present in the samples. To investigate the significant loss current observed in the experiments in more detail, we carry out device simulations accounting for the full 3D nanowire geometry. According to the simulations, the low efficiency of radial AlGaInP nanowire LEDs can be explained by a substantial hole leakage to the outer barrier layer due to the small layer thicknesses and the close proximity of the shell contact. Using further simulations, we propose modifications to the epitaxial structure to eliminate such leakage currents and to increase the efficiency to near unity without sacrificing the λ/2 upper limit of the nanowire diameter. To gain a better insight of the device physics, we introduce an optical output measurement technique to estimate an ideality factor that is only dependent on the quasi-Fermi level separation in the LED. The results show ideality factors in the range of 1–2 around the maximum LED efficiency even in the presence of a very large voltage loss, indicating that the technique is especially attractive for measuring nanowire LEDs at an early stage of development before electrical contacts have been optimized. The presented results and characterization techniques form a basis of how to simultaneously optimize the electrical and optical efficiency of core–shell nanowire LEDs, paving the way to nanowire light emitters that make true use of larger-than-unity Purcell factors and the consequently enhanced spontaneous emission. © 2017American Chemical Society

Place, publisher, year, edition, pages
American Chemical Society (ACS), 2017
National Category
Nano Technology
Identifiers
urn:nbn:se:hh:diva-34048 (URN)10.1021/acs.nanolett.7b00759 (DOI)000403631600041 ()28535346 (PubMedID)2-s2.0-85020753897 (Scopus ID)
Available from: 2017-06-10 Created: 2017-06-10 Last updated: 2018-04-03Bibliographically approved
Identifiers
ORCID iD: ORCID iD iconorcid.org/0000-0001-5694-9782

Search in DiVA

Show all publications